FLS single lamp controller is a single lamp controller with lamp networking interface developed by our company. It is used in conjunction with our company's single lamp control host to realize the function of single lamp control. The system uses industrial-grade hard-packaged chips to complete the system control, which has the characteristics of strong operability, high integration and good stability.
FLS integrates switch output, PWM dimming interface output, and 0-10V analog dimming interface output. The equipment adopts low-voltage power carrier technology (PLC), and is equipped with self-developed automatic routing networking algorithm to complete the precise control of a single lamp. Can meet the needs of the majority of users.
Operating Voltage |
85~265VAC |
rated power |
3W |
load capacity |
16A |
output loop |
2 way |
Dimming interface |
0-10V/PWM |
Insulation resistance |
Not less than 2MΩ |
Center frequency |
330KHz |
communication bandwidth |
±25KHz |
communication rate |
2.4kbps |
signal strength |
<8vpp |
Current accuracy |
1% |
Voltage accuracy |
± 5VAC |
Operating temperature |
-40 ° C-70 ° C |
Working humidity |
<95%(not condensed) |
Product Size |
135mm*65mm*40mm |
Leakage detection |
30mA (optional) |
1. Introduction of switch output function
The system uses built-in relays and active output switch signals to control the switch lights of the equipment and the dimming of the ballast. The output voltage is the input voltage source, and the load does not exceed 16A.
When switching output, the system has a three-level dimming function, that is, full on, energy saving, and off three states. Users can control the host through a single lamp to use together.
2. PWM dimming interface output introduction
The system has a PWM dimming interface, and the system has a built-in isolation circuit to protect the safety and stability of the equipment. The period of the PWM output signal is 400Hz, which is compatible with the mainstream LED driving power on the market.
3. 0~10VDC output introduction
The system has 0~10VDC analog output for analog dimming. The lamp adjusts the brightness according to the input current, and is compatible with the mainstream LED driving power on the market.
4. Protection function
The device has built-in overcurrent protection and overvoltage protection. When the on-site environment is over-voltage (greater than 270VAC), the device will automatically enter the protection state, and when the voltage is restored, the device will work normally.
5. Electric energy metering function
The equipment has the function of current and voltage acquisition, which is convenient for users to control the on-site situation in real time and provide the basis for on-site maintenance.